Black Smooth Brass Metal Studded Elevator Floor Tile

• Floor must be clean and dry. Remove any old floor covering and be sure the sub floor is free of all dirt and residue.
• Install quality white shield felt or saturated paper with multi-purpose adhesive if installing over steel or expect future removal. Allow to dry thoroughly.
• Use a two part epoxy with a 1/8” x 1/8” square notch trowel, so that there is enough adhesive to grasp the studs on the back of the tile. Spread adhesive and install tiles with smooth side up /the larger disc of the metal stud face down. Be sure to spread the epoxy uniformly covering the entire sub-floor surface. This is particularly important for the tiles
  being laid by an elevator door or other entry area.
• If any epoxy oozes at tile seams, it must be wiped away immediately. Once the epoxy sets, it is not removable.
• Roll with heavy floor tile roller.
  For ease of cutting at the wall, remove studs from the back by pulling out like a thumbtack.
• Adhesive Specifications can be found here for EW-710 or here for MR-721
  

Punch out material from holes available upon request.

• Can be installed over radiant heat, operational temperature must not exceed 85° to prevent damage to flooring.
• Not to be used in Commercial Kitchens or other areas subjected to animal, vegetable or petroleum based oils and solvents.
• Not to be used in areas subjected to sharp spikes, cleats, sharp wheels, stiletto heels or other objects that could damage the flooring.
• Not to be used in direct contact with heat sources or in outdoor applications.

• Sweep and wash floors with a neutral PH cleaner or mild detergent and water solution.
• Floor must be dried with a soft cloth. Never leave floor wet.
• Buff with a soft pad.