• Each studded tile is a nominal 12" x 12" x 3/16" gauge
• Each unstudded rubber tile is 12” x 12” x 1/8” gauge
• Each tile contains 144 studs; one every square inch
• ALL studded tile must be installed with a 2 part A/B Epoxy

Hammered (SE)
Gauge: 1/8” (3.175 mm)
Design: Random Dimples across Surface
Design Depth: 0.010” - 0.015”
Size: 12” x 12” (30.48 cm x 30.48 cm),

Smooth (SM)
Gauge: 1/8” (3.175 mm)
Design: Smooth Surface
Size: 12” x 12” (30.48 cm x 30.48 cm)

1. Floor must be clean and dry. Remove any old floor covering and be sure the sub floor is free of
   all dirt and residue.
2. Install quality white shield felt or saturated paper with multi-purpose adhesive if installing
   over steel or expect future removal. Allow to dry thoroughly.
3. Use a two part epoxy with a 1/8” x 1/8” square notch trowel. Spread adhesive and install tiles
   with smooth side up.
4. Roll with heavy floor tile roller.
5. For ease of cutting at the wall, remove studs from the back by pulling out like a thumbtack.
   Punch out material from holes available upon request.
6. Adhesive Specifications can be found here for FLEW-710

• Can be installed over radiant heat, operational temperature must not exceed 85° to prevent
  damage to flooring.
• Not to be used in Commercial Kitchens or other areas subjected to animal, vegetable or
  petroleum based oils and solvents.
• Not to be used in areas subjected to sharp spikes, cleats, sharp wheels, stiletto heels or other
  objects that could damage the flooring.
• Not to be used in direct contact with heat sources or in outdoor applications.

• Sweep and wash floors with a neutral PH cleaner or mild detergent and water solution.
• Floor must be dried with a soft cloth. Never leave floor wet.
• Buff with a soft pad.

ASTM F 1344, Rubber Floor Tile - Class I
Type A Solid Color

Fire Testing:

ASTM E 648 (NFPA 253)
Critical Radiant Flux - Class 1, > .45 W/cm2
ASTM E 662 (NFPA 258)
Smoke Generation - Passes, < 450

ASTM D2047, Coefficient of Friction (Slip Resistance) - > .6
ASTM D2240, Hardness - > 85
ASTM D3389, Abrasion – Passes <1gm loss
ASTM F925, Resistance to Chemicals – Passes
ASTM F970, Static Load Limit - 250 psi, Passes Max Indentation of 0.003” @ 1,500 psi